Beam Solaire Power Team Instrukcja Właściciela Pobierz pdf (Strona 4)

POWERBRUSH FEATURES

1. Cogged Belt – The cogged belt is designed for positive drive, and it will not stretch

or slip. The long life of the sturdy cogged belt also reduces the need for frequent

replacement to enhance cleaning efficiently.

2. LED Lamp – The super bright light of the LED (Light Emitting Diode) lamp

allows for better vision in poorly lit areas for more thorough cleaning. It is also

much more durable than incandescent or halogen bulbs.

3. Automatic Carpet Height Adjustment – The Powerbrush is equipped with two

small roller wheels at the front which keep the Powerbrush at the correct distance

from the carpet for optimal cleaning.

4. Circuit Breaker – The electronic circuit breaker protects the motor and the

cogged belt from damage should a motor stall occur due to accidental pick up of

a larger object. The LED light located on the back of the powerbrush (see Figure

1) will glow green in color for normal operation and flashing red in color for a

stalled or jammed condition.

CAUTION! TO REDUCE THE RISK OF INJURY, BRUSHROLL COULD SUDDENLY

RESTART, UNPLUG BEFORE SERVICING.

When brushroll jam has been cleared, circuit breaker can be reset by switching hose handle switch “off” then “on”. Your

Powerbrush must be serviced by an authorized service center if it continues to trip the circuit breaker.

5. Isolated Brush Compartment – The electrical compartment is totally separated from the sweeping area. This provides

user safety and shields the electric motor from dust and dirt to enhance motor life.

6. Dual Ball Bearing Brush Roller – The rotating brush mechanism utilizes precision ball bearings for extra smooth run-

ning and durability.

7. Chevron Brushroll – Pulls dirt to main airchannel.

8. Wheel Bearings - The rear wheels are equipped with sealed ball bearings providing a quiet long lasting assembly.

POWERBRUSH WIRING DIAGRAM

ASSEMBLY & OPERATING INSTRUCTIONS FOR THE POWERBRUSH

When using the powerbrush, the basic precautions outlined under “IMPORTANT SAFETY

INSTRUCTIONS” should always be followed.

1. Push the wand into the powerbrush socket until it locks in place. The wand socket is designed with a positive stop.

Therefore, the wand will not jam in the wand socket. (figure 3)

2. Make sure the hose handle switch is in the OFF position.

Note: The handle is in the off position when the slide switch is in the “O” position. (O I II)

Figure 3

(See page 2 for details)

Figure 1

1 2 3 4 5 6 7 8 9 ... 15 16

Brak uwag

Beam Solaire Power Team Instrukcja Właściciela Strona 4